|
Who's Online
There currently are 5710 guests and 1 member online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
PDF Contains
Technical Data, Mechanical data, Detailed Circuit diagram with components value, PCB layout. Actual PCBs Print. Component List, Spare parts code list and Input output detail. It cover LBB1211, LBB1212, LBB1213, LBB1216, LBB1217.
It is the actual Service Manual for SQ10
;
very good manual with clear electrical schemes. Very helpful to find wat was wrong inside my microwave.
;
Hi, thankyou for providing the Nordmende Globetrotter original manufacturer's repair manual. Quality is very good and sharp - the PDF file was comfortably small to download. The only question is: why did it take so long to become ready for download?? Many thanks anyway, I fixed the fault in the radio thanks to the circuit.
regards: Nick
;
This was super service.Ordered this manual and was reading the download an hour later
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
TROUBLESHOOTING
1. General Features
No. 1 Symptom No screen Cause Input error of inverter connector P804 and P704 connector being slipped out Check Point 1) Bend the pin legs of P1 connector -> recheck them 2) Check and repair F804. 1) Check and fix P704 connector 2) Check and fix the components at P704 LCD module and at main board. 3) Check Pin21. Check and repair tuner board and main board 1) Replace the inverter 2) Replace the LCD lamp 2) Check the connector input.
Cracked components and soldering at tuner board 2 Dark screen 1) Defective LCD lamp 2) Defective inverter 3) Input error of inverter connector
2. PC Mode
No. 1 Symptom Screen noise Cause Clock or phase being not able to be adjusted. Check Point 1) Resettig is needed according to the video card of each PC. 2) Horizontal noise : adjust phase until no horizontal noise occurres. 3) Vertical noise : adjust clock in menu until no vertical noise occurres. 1) Play the Auto Configure in Menu. 2) Adjust horizontal and vertical position until the screen displayes normally. Recheck adn repair JA202,IC202
2
Screen position error
Screen position error horizontally or vertically Soldering D-SUB Jack of JA202 and IC202.
3
Color beat noise
3. TV and external input
No. 1 Symptom No sound - Speaker - Earphone Cause Defective Reset IC of IC604. Defective MSP3411 of IC601. Defective B+(8V,5V) of IC603. Check Point 1) Check volume and speaker. - Sound comes out only when being inputted into Audio L/R. 2) Check after replacing IC604. 3) Replace IC601. 4) Check and replace B+ of IC603. Check the mould of shield and SJ209, Replace shield case. Re-soldering
2
Video color beat noise
Earphone shield case being touched. Soldering IC301 and IC510.
|
|
|
> |
|